PDA

View Full Version : What happens?



TTStefanoT05FX
05-29-2011, 04:18 PM
what happens if you get air bubbles in you rubber when gluing..

azlan
05-29-2011, 05:39 PM
Take it off and re-glue it again, and this time make sure there are no air bubbles

olvarox
05-29-2011, 07:09 PM
Take it off and re-glue it again, and this time make sure there are no air bubbles
Right on Azlan! :)

harrybelafonte
05-29-2011, 07:12 PM
buy another rubber for £65.99 or get a loan.

josh4209211
05-30-2011, 05:40 AM
it happened with me once, there was air bubble between 2 layers and when i re glue that, my rubber size was increased, what should i do now??

Matt Hetherington
05-30-2011, 06:38 AM
If the air bubble is between the blade and the rubber sheet then it will disappear if you remove the rubber and glue it back on again. If the air bubble is between the rubber and the sponge then if the ball hits it it will be like a sweat ball, the ball will just fall off your bat on contact, if you continue to use the rubber the bubble will grow so if this is the case unfortunately you will need a new sheet of rubber.

josh4209211
05-30-2011, 06:47 AM
yeah! i had to buy new rubber, but still i experienced the rubber and sponge stuff, i reglue 'em both and cut the increased surface, it was just waste of time, coz it didn't work as i was expecting, quality was down....~

WiWa
05-30-2011, 06:49 AM
Could b due to the type of rubber, my teammate had it a couple of times with some andro/tibhar rubber I thought, then with another brand he had no troubles. Not sure, but that might be it.

Lightzy
12-16-2018, 10:17 PM
Especially, considering that you can get an online loan :) pls loans (https://plscashadvance.com/installment-loans.html) are super easy to take and payback in short-term period of time.
ROFL AHHA good good


If you got a bubble under the sponge it's likely you'll have to get a new rubber because rubbers tend to shrink as you take them off the blade. Depends on the rubber though. Be careful with softer rubbers, glue them without stretching them and you should be fine. Don't put the rubber on the blade just like that. Roll it out carefully and gently onto the blade. You'll never get rid of the bubble because the bubble means that the rubber just isn't glued to the blade where the bubble was.

Ioiettino
12-16-2018, 11:17 PM
Get on board Lightzy, let's go fix that rubber!

18056

Lightzy
12-16-2018, 11:36 PM
Roflcopter

Der_Echte
12-16-2018, 11:55 PM
It is sad only TTD oldtimers remember what a value to the forum Azlan brought...

ttmonster
12-17-2018, 12:08 AM
It is sad only TTD oldtimers remember what a value to the forum Azlan brought...
https://wallpapercave.com/wp/wRFGXBO.jpg

yogi_bear
12-17-2018, 01:01 AM
check if it is just in the glue or topsheet separation from the sponge.

Loopadoop
12-18-2018, 03:51 AM
Don't over react, take the rubber off, let it sit for up to a week to dry, then should be normal to use