Topic | Replies | Views | Last Updated | ||
---|---|---|---|---|---|
Hi everyone,
I'm a little confused.. It is said that most chinese rubber work best with chemical boosting. Can we use boosters and still compete...
|
22 | 1K | |||
![]()
Hello, so I want to buy Hurricane 3 (bh) and Skyline 2 (fh) and boost them with Falco Long. Is it better to buy the NEO versions and boost them...
|
9 | 1.3K | |||
Hi,
Moving on from a previous thread ‘ Boosting H3 Neo National’ , the last post I made on that thread was to try boosting 2 sheets of rubber in...
|
44 | 3K | |||
![]()
Hey!
So a very quick question which I hope will receive a quick response! Basically, I ordered two rubbers from PROTT (FH/BH H3 NEO National);...
|
182 | 23.5K | |||
![]() ![]()
COOKERY CORN STARCH FOR CONDITIONING WB GLUE
Pick up some cookery Corn Starch for getting a thin ranny WG up to high viscosity glue.. Corn Starch...
|
1 | 342 | |||
I wanted to boost H3 Neo Commercial but it didn't turn out as I would expect.
First I put on a layer of solvent based glue on the rubber, and then...
|
13 | 1.4K | |||
Legalizing non VOC booster will be proposed at the next ITTF AGM on 1st of May, 2018.
75% of votes are needed for an approval.
...
|
87 | 10K | |||
I'm looking to buy 1L WBG to boost the rubbers, I want to know your experience about what WBG is the best to boost the rubbers?
|
5 | 948 | |||
Hi Everyone,
I can understand why people boost the typically tacky and hard sponged Chinese rubbers, and additionally boost Chinese rubbers /...
|
37 | 3.1K | |||
I have always used kalin oil and I have always found it good on Tendergy both for its effect and for its duration, I have always done maximum 3...
|
40 | 6.3K | |||
Hello, I'm looking for a cheap sponge I can find on amazon to apply glue.
I also wanted to ask if there was anything wrong with using those magic...
|
6 | 833 | |||
Dammit, my WBG just dried again... Around 150 ml or so...
How do you store WBG so that it won't dry?
or is it impossible for WBG to not dry? :/
|
14 | 1.8K | |||
Hey guys,
Can anyone who has used both Revolution glue and DHS #15 glue tell me which viscosity of Revolution (normal, medium or high) most closely...
|
2 | 1.1K | |||
Curious to know this. I’m thinking of getting a Yasaka Rakza z or z hard and I’m going to boost it but I want to know how much it softens the sponge...
|
5 | 782 | |||
I know that for a long time speed glue is banned, however i play on a level nowhere near where this is a problem. Currently in my closet i have 2...
|
8 | 1.3K | |||
