Post again here about how I boost my new rubbers.
I am using haifu black oil and nittaku fine zip glue. Boosting is only for the brand new rubbers and I am only use hurricane 3 neo version.
After open the packaging:
1. Put first layer of oil on, wait for 1 or 2 days till oil gets dry, which means there is no finger print when press the sponge
2. Second layer of oil on, wait for 1 or 2 days till oil gets dry
3. First layer of glue on, when glue gets dry, then put third layer of oil on, wait for 1 or 2 days till oil gets dry
4. Put fourth layer of oil on, wait for 1 or 2 days till oil gets dry
5. Second layer of glue on, then the rubber is ready to put on the blade.
If you want to make the oil get dry quicker, could use a small fan or put under the windows. The key thing is that make sure the oil gets dry properly each time, especially the last time before you put the last layer of glue on.
Basically, there are three layers of glue (neo version has one premade layer of glue) and four layers of oil on the rubber. Two layers of glue on the blade. After put rubber on the blade
This is how to boost the rubber after I tried different ways and I found this is the best for myself. Just for your reference. Hope this helps you.
Enjoy boosting boosting boosting......
I use heavy books to put on top of the blade and rubber to let them settle down for a couple of hours before cutting.