I purchased the Advance robot over a year ago but recently having problems with it and wondering if anyone else has had similar issues.
Whenever I set up a drill (upto 6 balls) and try to start the Robot or try and save the Routine, the robot resets and I lose all my settings.
If i do a 1 ball routine or retrieve a saved program robot works ok most of of the time.
Someone else has reported a similar issue on another forum and mentioned that this could be cause by static when touching the controller and Butterfly should have isolated the circuit board better?
Any help appreciated....
Whenever I set up a drill (upto 6 balls) and try to start the Robot or try and save the Routine, the robot resets and I lose all my settings.
If i do a 1 ball routine or retrieve a saved program robot works ok most of of the time.
Someone else has reported a similar issue on another forum and mentioned that this could be cause by static when touching the controller and Butterfly should have isolated the circuit board better?
Any help appreciated....