This user has no status.
This user has no status.
Member
Hi,
Though I had no immediate requirement but as I was getting a good deal on a Stiga Infinity VPS V blade, i went ahead and ordered one. I read some posts on blade sealing and my understanding after reading those is that it depends on number of factors, such as the outer layer of the blade, glue, booster and frequency of changing the rubbers. In my case, my typical usage would be with a boosted DHS hurricane 3 Neo rubber on Forehand, fast rubbers such as Nittaku Fastarc g-1, or Yasaka Rakza 7 or Rasanter r47 on backhand glued with Evolution no. 3 glue and might change the rubber every 6+ months. According to this link, it seems that Infinity has Limba on it's outer layer. Please advice if I should or shouldn't go ahead with blade sealing.
Though I had no immediate requirement but as I was getting a good deal on a Stiga Infinity VPS V blade, i went ahead and ordered one. I read some posts on blade sealing and my understanding after reading those is that it depends on number of factors, such as the outer layer of the blade, glue, booster and frequency of changing the rubbers. In my case, my typical usage would be with a boosted DHS hurricane 3 Neo rubber on Forehand, fast rubbers such as Nittaku Fastarc g-1, or Yasaka Rakza 7 or Rasanter r47 on backhand glued with Evolution no. 3 glue and might change the rubber every 6+ months. According to this link, it seems that Infinity has Limba on it's outer layer. Please advice if I should or shouldn't go ahead with blade sealing.