Back to Forum
Results 1 to 5 of 5
  1. Dman is offline
    This user has no status.
     
    TTD Member 0 29
    D
    Dman is offline
    This user has no status.
     
    TTD Member 29 0
    #1

    How many degrees does boosting a rubber soften the sponge by

    Curious to know this. I’m thinking of getting a Yasaka Rakza z or z hard and I’m going to boost it but I want to know how much it softens the sponge by so I can decide. ideally I would like it around 48 to 50 degrees.

  2. yogi_bear is offline
    This user has no status.
     
    Master TTD Member 2,891 5,963
    yogi_bear's Avatar
    yogi_bear is offline
    This user has no status.
     
    Master TTD Member 5,963 2,891
    #2
    The newer esn sponge right now seem not to soften much with boosting unless it is not less than 3 to 4 layers of boosting and that depends also on the booster being used.

  3. Dman is offline
    This user has no status.
     
    TTD Member 0 29
    D
    Dman is offline
    This user has no status.
     
    TTD Member 29 0
    #3
    I will be using Falco tempo long booster

  4. yogi_bear is offline
    This user has no status.
     
    Master TTD Member 2,891 5,963
    yogi_bear's Avatar
    yogi_bear is offline
    This user has no status.
     
    Master TTD Member 5,963 2,891
    #4
    It will only soften a lil bit using falco but curling will be hard to flatten.

  5. Dman is offline
    This user has no status.
     
    TTD Member 0 29
    D
    Dman is offline
    This user has no status.
     
    TTD Member 29 0
    #5
    Ok thank you

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Create a new Topic:
Title is required.