I have used two ways. I think both are shown on Youtube. However, the easiest way is to use a glue sheet but some people don't like glue sheets. The first method I used required taping the 0X sheet to a wine bottle on the top two corners and rolling the sheet on to the blade. The second method I used required wax paper that was placed on the glue on the blade. Then the rubber was placed on the wax paper. Then the wax paper was pulled out slowly making sure the rubber made good contact with the blade and no loose spots or bubbles. I like 755 0X because it is cheap. It isn't the best at anything but a very good compromise LP 0X. The down side is the base of 755 0X is very thin so it is difficult to apply. Don't apply glue to the rubber. It will curl and it never really goes back to its original shape.