Results 1 to 14 of 14
-
DTTD Member 1 17
This user has no status.TTD Member 17 1
This user has no status.01-05-2022 1641429288 #1fh rubber reccomendation
Hello, I normally play with hurricane 3 neo on fh and rakza 7 on the backhand of my dhs fb2 For fun I tried flipping my racket around to see what it would feel like and I actually liked it quite a lot more than the h3. My issue is that I keep bottoming out the sponge when I counterloop hard, this sucks because it is my best shot and it feels horrible when I go full force. It would also be nice to have a bit more grip to make my topspins more dangerous. Could someone recommend me a new rubber?
-
BAdvanced TTD Member 164 478
This user has no status.Advanced TTD Member 478 164
This user has no status.01-06-2022 1641432182 #2
H8-80
-
Established TTD Member 38 180
says Takkyū wa tanoshīdesu!Established TTD Member 180 38
says Takkyū wa tanoshīdesu!01-06-2022 1641433847 #3
-
DTTD Member 1 17
This user has no status.TTD Member 17 1
This user has no status.01-06-2022 1641434290 #4
-
Established TTD Member 38 180
says Takkyū wa tanoshīdesu!Established TTD Member 180 38
says Takkyū wa tanoshīdesu!01-06-2022 1641434705 #5
Hard tensors i really liked, is the Gewo ones. Gewo Nexxus XT Pro 50 Hard have low arc like chinese ones, but have the speed who chineses dont have. Maybe Nexxus EL Pro 50 if you want a more high arc. In my hands i found the Gewo Nexxus rubbers very good. I used the Pro EL 53 Hard for some time but is too hard, you need a full swing and good brushing technique. Try The XT Pro 50 if want some low arc as H3 but more speed than H3. I think if you liked Rakza, try Rakza Z
Last edited by davizoosk; 01-06-2022 at 01:08 AM.
-
Established TTD Member 2 105
says BismillahEstablished TTD Member 105 2
says Bismillah01-06-2022 1641441059 #6
-
FAdvanced TTD Member 84 231
This user has no status.Advanced TTD Member 231 84
This user has no status.01-06-2022 1641442203 #7
Hi,
Over 80% of the Modern (especially the current Generation) Tensor(oids) would be good @ counter-looping..
- Tenergy 05
- MX-P (My Personal Fav, for counter-looping)
- Omega VII Pro
- Rasanter R50+
- Dignics (05) (I also like this, but don't have pockets deep enough for it)
The Following User Likes Funk Fu Master's Post:
Equaaz
-
Senior TTD Member 353 573
says May the Spin be with you!Senior TTD Member 573 353
says May the Spin be with you!
-
Advanced TTD Member 116 347
This user has no status.Advanced TTD Member 347 116
This user has no status.01-06-2022 1641458512 #9
You could try the Xiom TAU II. It feels like a H3N, but with more bounce. Otherwise just boost your H3N a bit with Haifu Seamoon Booster, and you get a softer feel. An alternative is to go for the H3N Provincial Orange Sponge. I just replaced my boosted H3 41deg with a H3N Prov OS 40deg, boosted two layers. It gives you a bit more control and still the speed and spin.
-
DTTD Member 1 17
This user has no status.TTD Member 17 1
This user has no status.01-06-2022 1641475743 #10
-
PAdvanced TTD Member 233 414
This user has no status.Advanced TTD Member 414 233
This user has no status.01-06-2022 1641476060 #11
Fastatc G1 is my favourite at the moment. It's kind of Inbetween modern ESN and Chinese.
The Following User Likes passifid's Post:
Manto76
-
DTTD Member 1 17
This user has no status.TTD Member 17 1
This user has no status.01-08-2022 1641677767 #12
-
DTTD Member 1 17
This user has no status.TTD Member 17 1
This user has no status.01-08-2022 1641681471 #13
-
CTTD Member 5 28
This user has no status.TTD Member 28 5
This user has no status.01-09-2022 1641737767 #14
i played both g-1 and rakza 7 before. g-1 needs more effort to bottom out and since Nittaku released Fastarc G-1 in the new Max Thickness, aka thicker sponge , you shouldnt be facing bottom out issues.
just make sure with the shop that the sheet of G-1 you are buying is not 2.0mm thick, the MAX version is thicker.
Reply to dAbandit0's post
DHS Hurricane HAO II (656)
BH: Nittaku Fastarc G-1
FH: Tibhar Evolution MX-P 50º
Originally Posted by bzing
