Recent content by Larshos

To anyone else wondering, "lwk pmo" is not a typo, but intentional and means "low-key pissed me off", apparently. Try your best not to get glue on the blade edge when applying glue. That's usually where the edge tape can grab onto any residual glue and wreak havoc when removing edge tape. The...

I also use several passes, the first being the critical one when you cut through the glue layer on. It seems like the separation happens here.. I have the Rev. no. 3 scissors, issue with those for me is that the blades' top ply tend to chip slightly from the rubbing of the metal on the blade...

Is it possible to not get a millimeter of separation or so, between rubber and blade, when trimming the rubber flush with the edge of the blade after gluing? I use a sharp 9 mm "snap off" utility knife, but unless I cut with some overhang on purpose it always seem to be a bit of separation.. Is...

Ahh ok, I thought it was way longer!

Time from ordering to delivery :)

What was the lead time on the blade?

You have girlfriends??

Taken from TokSpin.com (same person/business as Chinese PingPong on Aliexpress):

Interesting. Have you measured your hand size, for context?

Tibhar BSS1 in ST. Having medium-high hopes for the handle being suitable for me.

Does anyone know if this is a Daiki or ESN made rubber?

eBay is different to Amazon. eBay works similar to Aliexpress, but on an international level.

Would you mind sharing the width, height and length of the handle?

To me this seem very similar to Parla.. How do they differ? Which will be faster?

So you're then using your thumb actively to counteract the torque you put on the axis of the length of the blade?