Recent content by palguay

instead of doing manually, could you parse the result page and extract the data and enter it programmatically ?

Hi everyone, We wanted to see how two entry-level rubbers behave on a standard neutral blade (Yinhe N10). Specifically, we wanted to check if they are linear or if they have distinct "gears" at this price point. We used a robot to feed balls at Low Speed (~13km/h) and Mid Speed (~21km/h) and...

Hi everyone, I recently decided to run a small experiment to visually compare the rebound speed between a factory-stock DHS Hurricane 3 and a boosted version. I know this is a topic that gets discussed a lot, but I wanted to actually see the difference in "exit velocity" without the variable of...

ok, what do you think of the earlier video where we put the numbers, I am trying to understand if those make sense to you or even that would be flawed ? this is something not done earlier so we know that we are going to fail a lot before we get to the meaningful numbers. spin and speed numbers

to be fair no one has attempted this before, collecting data in this scenario is messy, each video I change one small thing. it might take some time but we are confident that the process will get better over time, at this point what is available is someone hitting a ball and claiming it is fast...

In this video, we tracked the specific arc and landing zones of the Zyre 03 compared to the Dignics 09c (same blade, same stroke). The visual markings really highlight how the flight path changes. For those who have played with Zyre 03: Does this visual match the "feeling" you get at the table...

True, I am looking at finding someone with that combination so that I can borrow it for testing.

There will be some variance but I am thinking if I hit say a few topspin with zyre and then repeat it with dignics 09c then on an average we should get some objective data. If this works then I can ask other players to do the same and then we get some valid numbers thinking of something like this

There are different ways to look at data, one is without any external force, this is for that. I am planning to do some with me playing topspin with both and collecting information on the spin and speed which will be another set of data

true, I want to do that but I will have to either buy a D05 or find someone who uses that combination and borrow it for testing

We set up a controlled lab test to measure the actual Input vs. Output energy of the rubber. Instead of just hitting and guessing, we calculated the incoming ball speed/spin and measured exactly what the ball looks like leaving the racket. The Setup: Blade: Butterfly Viscaria Super ALC Red...

We ran a small test to see what really happens during a topspin–block rally. Recorded everything in slow motion and measured the ball’s speed and spin at different points: after the topspin leaves the attacker’s racket just before reaching the blocker after the bounce after the block...

Did a follow-up set of photos after cleaning the same rubber from the earlier post. This time, you can clearly see how the surface looks without as much dust as earlier- the middle area still shows wear, but the texture is more even and the small dust spots are lesser.

Took a few photos of a used rubber today. From far and when zoomed in, you can see the dust spots and the worn-out part of the rubber in the middle, compared to the edges. Planning to do another set of photos after cleaning to see how much difference it actually makes in texture and appearance.

Interesting idea , I don't know about airtag features but it is a bit expensive, the target price I am looking us around USD 20 for this