ripctt2's latest activity
-
I stand on it simply because it's easier but I reckon rolling with a rolling pin and applying good pressure could also be enough but it...
-
ripctt2 replied to the thread sanwei rubber cutter without press.wait i just read your post again. did you say: stand on the top one??? would pressin down with your hands be sufficient?
-
ripctt2 replied to the thread sanwei rubber cutter without press.what wait but is the overhang liek a lot of a tiny bit? i think i might get two wooden board and then ress hard on the top to reduce any...
-
I bought this to mess around. They give you a rod to roll it with, but it's definitely better if pressed. Rolling works but you have to...
-
ripctt2 replied to the thread sanwei rubber cutter without press.I think im going to get it then to cut my rubber next itme. Last time i used a box cutter to cut it and it almost broke the knife. like...
-
Yes, it works perfectly. I have the very same item, I bought it last year and I've done three rackets with it including one just 3 days...
-
So i looked on aliexpress and found somehting similar to the sanwei rubber press (or machine idk tbh)...
-
ripctt2 replied to the thread butterfly shoes (regional and commercial) models.any1 have any other thougts?
-
ripctt2 reacted to shypre's post in the thread butterfly shoes (regional and commercial) models with
Like.
I bought the Butterfly L-12 on Taobao and they look exactly like the Lezoline Rifones. The other L models also look the same as the... -
ripctt2 replied to the thread butterfly shoes (regional and commercial) models.Yeah but I can't seem to find lezoline 10 or 7 or any of the shoes in the tc sereis. I see a bunch of them listed on taobao but just not...
-
ripctt2 replied to the thread butterfly shoes (regional and commercial) models.^
-
ripctt2 posted the thread butterfly shoes (regional and commercial) models in General Discussion On Table Tennis.So just had a question, from looking at the butterfly china website https://butterfly-china.com I saw that there werte many models that...
-
ripctt2 replied to the thread A bit of a weird one.3 months old. but its not really affecting anything. just wanted to knoiw if there wa sany solution to keep the topsheet colour consistent
-
i use an old school shaving razor, snap it in half and use it carefully like a saw, on the jagged parts.
-
ripctt2 replied to the thread A bit of a weird one.uhm i dont have either. would sanding it work or would it just tear the sponge?
