When to reboost

[imbadatlooping]

Hey everyone. About a month ago I boosted my DHS H3N Prov OS 39 degree sponge with national yellow booster for the first time (First ever H3N sheet and first time boosting). I have a tournament coming up on the 26th and 27th of this month and was wondering when i should reboost (if at all). I boosted it with two layers but have not felt any difference as far as the playing characteristic of the rubber. Should I boost again this week/next week so it has time to break in before my tournament or should i just leave it be and not reboost it? Im afraid that if i reboost now ill ruin it and not have a FH rubber to play with in the tournament lol.

 

[MOJOJOJO-74]

Did you put thin layers or thick layers on? It definitely makes a huge difference whether you use little or a lot.

 

[imbadatlooping]

Did you put thin layers or thick layers on? It definitely makes a huge difference whether you use little or a lot.

I think i put medium layers on their. I brushed of the sides of the booster brush and that was pretty much it. Im not really sure how thick the layers i put on it were.

 

[MOJOJOJO-74]

I think i put medium layers on their. I brushed of the sides of the booster brush and that was pretty much it. Im not really sure how thick the layers i put on it were.

How are you playing with it right now? Personally, I wouldn't risk doing anything to your equipment in such a short time because you're already used to how your H3 plays.

 

[Archosaurus]

No such thing as a "break in" as far as I know, but you should let the booster soak for at least a few hours before gluing. The recommendation by Haifu is 12-24 hours at NTP (So probably 20c and 1atm) but I've glued before that and it doesn't seem to influence it that much. It'll be soaked in by 4-5 hours. I could never measure any stiffness difference after 12-24 compared to 4-5, but the diameter may be different ie: tension different.

If you don't have a bat press, or if you wanna be more sure, then you should wait that 24 hours anyway before gluing just so the edges don't peel. You might need to wait closer to 72-96 hours if you go crazy with it and put on 3 thick layers. You probably don't need 3 thick layers if it's your first H3 sheet and you're using a soft sponge like 39A.

The edges will still peel when so boosted even if you use a bat press, but it should survive one tournament. Use a lot of glue. 3-5 layers on sponge and 2-3 on blade depending on the viscosity. Of course the sponge thickness has to be conservative to actually pass racket control, but I suspect they don't do it at your tournament.

You didn't say exactly how much you boosted and what the resulting hardness was so it's hard to say if boosting more will ruin it or not, but generally I wouldn't go under -5 hardness if possible.

Yellow will soften the sponge quite a lot, so you need to be a bit careful, although bear in mind that just taking the rubber off the blade will revert most of its hardness hence why you wanna measure it to know what you're dealing with.

I'm sure it's fine to put on 1 layer if you feel like it, and glue it with 3 on the sponge and 1 on the blade. Leave it in a bat press over night and it won't peel much at all. Play with it immediately next day for the best effect although it can be risky if you're not actually used to how freshly boosted and glued rubbers play.

 

[Lazer]

I boost my my H3 (nom NEO) once, and never again. It degrades so slow that I get time to adjust. Then I change it every 6 months to 1 year.

Cheers
L-zr