sticking

Letting rubbers "breathe" before sticking them on (in order to reduce shrinkage)? Hi Guys, I've seen a posted on you-tube which suggests that you should leave new rubbers out of the packet to "breathe" for about 72 hours in order to allow any shrinkage before putting them on the blade, rather...

Hi guys, How do I stick rubbers that are used and have shrunk slightly onto my blade as there will be a gap around the edge if I stick it normally. Thank you!

Fred got a couple of new rubbers yesterday, so being as I was looking for something to do, I made a vid showing how I make up a bat. I know most of you will be pretty good at this sort of thing, but for anyone who is looking for a rough guide then this could be useful. Just before 6 mins, it...