Activity Stream

Hi Coach, What is it about the elbow that you want me to notice. Sorry l am lost on this... 😅

Having played against UONTT 2nds and a few of their top players over the years, I can safely say this is the best victory you guys have put together....

You have a keen eye friend. You notice something that is so minute. Yes you are right, I am having trouble adjusting my grip. Right now I have a...

There will be some inter-club friendlies in June-22. Some players from other states will come and play with my club and I hope to get some match play...

Taking some time to practice my Deadly Serves😂 How does one know whether the quality of serve is good or not during practice? Listen to the sound...

To me it really doesn't look that bad. Random is so much harder than a known drill like 2 bh - 2 fh or whatever. It's not twice as hard, it's 10x...

Here are my impressions. For the most part, this blade largely delivers on the traits that a limba inner zlc blade would suggest. Considering it was...

I tested it with Big Dipper 39d on FH and Moon Speed on BH

That layer is sticky as any glue, it can't be booster, oils are not sticky, right? It is some sort of glue. ​​​​​​

I'm not allowed to comment but look at harimoto in the following video. Look at what his elbow is doing in the backswing and compare it to yours. See...

What rubbers are these?

Booster does not form a layer on the sponge. As it dries out it completely disappears. The glue -layers crudely applied over the boosted sponges is...

Nice, I’ll definitely get a Pro once they start selling. I did however just got the TMXi today, sealed it just now, and I’ll be trying it out...

the guy in the mlfm video showed side under. The guy you showed was doing side top/only side. The elbow doesn’t come up for side under because you...

If you hit forehand more in front of you, around the same place you hit your backhand your bh-fh change will really improve. Can also try to have...

A direct comparison with the apolonia blade should be interesting. Kind of hoping Gan gets a hold of one of these.

and finally my coach made me do random FH and BH transition. I really still suxs at FH to BH transition and vice-versa. More so when my coach blocks...

My new and improved BH drive, hopefully...

My BH to FH transition. Still not up to my own expectation. I should be able to do this much more smoothly.

Hi everyone, It has been two months since I last upload my video. The above is my FH drive.

Yep. Also confused about what I'm reading here. Any high tension rubber will shrink if you glue it on and subsequently remove it. I always cut my...

https://www.tabletennisstore.us can purchase here too. Replied by the store : TMXi will be available later in this week and TMXi Pro in the...

The "glue layer" on the rubber is not glue, but booster. You still need to add glue to those rubbers. Depending what type of glue you use, you...

I didn't put any glue on H3 Neo rubber that already has factory glue layer on it. Just on the blade. Is the second layer of glue needed?

I've used a lot of Yinhe rubbers (and some others) with the factory glue layer and always glue just the blade. I've never had any problems. Actually...

I highly suggest putting another layer over yinhe pre glued sheets. They are way too strong.