ripctt2's latest activity
-
Hello guys, tested my setup for nearly a month. Went for the butterfly hadraw sr(7ply wood blade) with Dignics80 on the forehand and...
-
ripctt2 replied to the thread Equipment Advice.ive actually never heard of that blade before. i think its discontinued is it not? whre did you get it? aside from that 7 ply wood is...
-
ripctt2 replied to the thread FS: Butterfly ZJK SZLC Special 70th anniversary edition.special 70th anniversary blade. super rare i think. in terms of the blade's composition to the normal one, i think its the same... im...
-
ripctt2 reacted to NDH's post in the thread FS: Butterfly ZJK SZLC Special 70th anniversary edition with
Like.
OK, well that was an entertaining read. I've deleted a load of comments that are against forum rules (some were well intended, but... -
ripctt2 replied to the thread Help me see the difference between rubbers.just note i was referring to glayzer 09c. the regular glayzer is slightly worse in terms of serve returning. although most online video...
-
If you have a problem receiving serves you definitely don’t want Tenergy, specially not Tenergy05. Cheers L-zr
-
ripctt2 replied to the thread Help me see the difference between rubbers.Tenergy is quite spin sensitive and relatively bouncy so it isnt very good but its doable if you have good control. glayzer 09c is quite...
-
ripctt2 replied to the thread Help me see the difference between rubbers.As for the rubbers bit, you said it doesnt have enough "curve" or arc. Althouh i havent tried stiga rubbers before, i would assume that...
-
ripctt2 replied to the thread Help me see the difference between rubbers.Hi there. Next time avoid posting topics that have been covered. I wrote this in another post: " Tensor rubbers are typically liek ESN...
-
I have a much clearer idea now, thank you. Is it very difficult to switch from Tensor rubbers to hybrid rubbers?
-
ripctt2 replied to the thread Tensor vs Hybrid rubbers.I suppose not but due to the fact that theres at least a mildly tacky topsheet, you may need to adjust your technique. It becomes more...
-
ripctt2 replied to the thread Tensor vs Hybrid rubbers.Tensor rubbers are typically liek ESN rubbers you'd find. Super bouncy, harder to control than your generic untensioned rubber. the...
-
ripctt2 replied to the thread sanwei rubber cutter without press.ohh i see
-
ripctt2 replied to the thread sanwei rubber cutter without press.i was considering getting that but it was a bit expensive at 99 aud so i wasnt going to get it. it seems a bit easy to accidentally roll...
-
ripctt2 replied to the thread sanwei rubber cutter without press.i suppose ill use a rolling pin cuz im not entirely sure what netprophet means by standing on it. as in setting it on the floor and then...
