Search results

Check your scale, that’s too much difference. Cheers L-zr

Leave it, any further action will risk the situation to become worse… Cheers L-zr

Remember that H3 like to be brushed for high spin... So yes the right technique is required. It has a lower throw than most ESN rubbers. You should open your racket angle ever so slightly compared to an ESN rubber except when brushing, but then you need to hit hard. Cheers L-zr

I just tested the Tajii Plus 2023. Its not the fastest or the most spinny, but I play a controlled game on BH so I don't benefit from too much of either. I put it on a Nittaku S-CZ with H3 (non neo)39 BS on the other side. I relly love how this blade feels and the Tajii didn't dissapoint. It...

in this case the mistake was to fuel the fire. it would have been better to ignore the foul posts. cheers L-zr

Ha, ha.. There is one of each on the handboll scene. Didn’t know this… Cheers L-zr

Not quite… Appelgren (table tennis) vs Apelgren (handball)… Cheers L-zr

A 7ply is generally stiffer and heavier. If You want a slower outer carbon I would recommend Donic Appelgren WC 89 or Nittaku S-CZ. Those two are very similar, built by Soulspin in Germany. Even though they are outer they are quite soft and great feeling to play with. The only thing is that the...

Long lasting as well? Cheers L-zr

If You are a top elite player then maybe yes... But for mortals it's a hunk of horse sh-t. I wouldn't recommend something as soft as a Donic Appelgren allplay (too flexy imo) but thats what my club recommends to starting kids in my club. But a 5ply all wood in the region of 6mm is an excellent...

You guys are incredible, so many conspiracy theories. The plain truth is that Truls was spent already and couldn’t muster up enough energy. Cheers L-zr

An arm and a leg.... Cheers L-zr

The most important bit that you don’t go too fast… I would start with än allwood blade a little flexible. 5 layer around 6mm thick. If you desperately want a carbon blade, I really really like the Donic Appelgren WC89. It’s an excellent blade. With this I would go with something with low...

I know, some people here like to spread conspiracy theories... Cheers L-zr

On weekly special this week. https://www.tabletennis11.com/other_eng/nittaku-miyabi Cheers L-zr

The power is in you not in your equipment. The danger with too fast setup is that you will start to hesitate and that’s baaad for you… Switch your blade to a not too fast blade that you can use for a long run time… Of in doubt go allwood < 6mm thick… Cheers L-zr Cheers

TT11 and chtt.se… and butterfly Germany if I incidentally have an urge for butterfly stuff… Cheers L-zr

A community full of dirty old males… What do you expect? 😱 Cheers L-zr

The frequency only tells you the blades stiffness (and hardness to a certain degree). More often than not a blade with higher frequency is faster but not always. Cheers L-zr

Don’t know what DHS sealant is it contains. But I would never seal the handle regardless, it’s not necessary. I’m with upside down Karl on this, sweat makes it better and if it’s properly glued it will never detach… Cheers L-zr