For any anyone who has experience with this blade what do you say about it's build quality, is it the type of blade that needs laquering or not, since i prefer not to use laquer unless it is necessary.
Thank you😊
Thank you😊
If you don't want to varnish, use speed glue, at least of the blade portion. Less adhesion, less splinters.
The best is WBG for the rubber and speed glue for the blade. This way blade is clean when you remove the rubber and you can rip off the sponge part more or less in a single piece.
+1
This method is proven the best one for me too, until now
The only downside is some blade's printing on the head are easily damaged by the speed glue/rubber cement solvent. But who cares, as long as the blade is not splintering 😂😂😂