Trick to not crater the sponge

[merlin el mago]

The best trick to not crater the sponge when you remove the sponge it's to apply booster and let it dry, as everybody knows the oil it's very good against adhesives, of course you must be careful removing the glue but you will see how easy it's to remove the glue.

 

[plunder]

magic

 

[igorponger]

KNOWLEDGE IS POWER, MONEY AND PLEASURE. FEEL FREE TO ASK FOR AI ADVICE ABOUT EVERYTHING.

Homemade glue similar to DHS 15 . Is it feasible? Yes, of course.,,, take up a consultation from GOOGLE AI first.

Google Search

NOTE Be sure you to enter liquid soap a bit into crude Latex sap. This is the key.

 

[riemsesy]

seal the blade too
and magic

 

[Tyce]

KNOWLEDGE IS POWER, MONEY AND PLEASURE. FEEL FREE TO ASK FOR AI CONSULTATION ABOUT EVERYTHING.

Homemade glue similar to DHS 15 . Is it feasible? Yes, of course.,,, take up a consultation from GOOGLE AI first.

Google Search

NOTE Be sure you to enter liquid soap a bit into crude Latex sap. This is the key.

DON'T LET LANGUAGE MODELS CONTROL YOUR CREATIVITY, CREATE YOUR OWN CONTENT

AI is cheating. Taking content from a language model, trained on other people's content is basically plagiarism.

 

[merlin el mago]

seal the blade too
and magic

Seal the blade protect the blade not to crater the sponge when you take off the glue.

 

[jonyer80]

Hair dryer heat will soften old glue for a while. Then you can rub with your thumb to remove the glue with ease. Patience is the key

 

[merlin el mago]

Heat is good to soften the glue but can harden sponge, I also use my thumb to remove the glue with care.

 

[NetProphet]

The best trick to not crater the sponge when you remove the sponge it's to apply booster and let it dry, as everybody knows the oil it's very good against adhesives, of course you must be careful removing the glue but you will see how easy it's to remove the glue.

Some sponges just absorb lots of glue. Rakza rubbers are an example and the glue is just infused inside the sponge wrapped in the air pockets/bubbles.
This is why Rakza sponge 'craters' when removing the glue.

I'd imagine the booster may help sometimes but I don't know a booster that breaks down the glue so this is just a permanent problem on certain sponges.

 

[merlin el mago]

Of course depends the sponge hardness & the glue used, I use hard sponges and high viscosity latex base WBG.

Some people adds more layers of high viscosity WBG & let it dry to have a thick layer to be more easy to remove, that also works.