Tenergy 05 2.1 mm or 1.9 mm

[amitmnagarwal]

On fzd alc, which ten 05 thickness would be suitable,

Is weight difference noticeably?
Is spin and speed difference in 1.9 mm?

 

[Gozo Zyreruna]

2.1mm if all out attacker
1.9mm if controlled looper / attacker

 

[Zezima]

go for max thickness if you go for a rubber like ten 05. If you are too scared because of 0,2mm then reconsider and play a different rubber.

 

[SFF_lib]

Go for 2.1mm. FZD ALC is already very soft.

You spin the ball by engaging it into the sponge. Thinner sponge has less spin capability.

 

[amitmnagarwal]

go for max thickness if you go for a rubber like ten 05. If you are too scared because of 0,2mm then reconsider and play a different rubber.i

I was feeling low weight of the thin sponge a benefit in addition to more control

However if it gives less spin, then an issue

 

[amitmnagarwal]

Go for 2.1mm. FZD ALC is already very soft.

You spin the ball by engaging it into the sponge. Thinner sponge has less spin capability.

Do u use fzd alc

 

[SFF_lib]

Do u use fzd alc

I have played with it, I still own it.

 

[Tony's Table Tennis]

1.9mm will be lighter for sure, but the sponge to topsheet ratio is altered, and there will be more wood than sponge compared to 2.1mm during contact.

so less spin would be the case.
I would rather, find a blade that is lighter by 1 to 2 grams, than sacrificing on the sponge thickness.

 

[amitmnagarwal]

1.9mm will be lighter for sure, but the sponge to topsheet ratio is altered, and there will be more wood than sponge compared to 2.1mm during contact.

so less spin would be the case.
I would rather, find a blade that is lighter by 1 to 2 grams, than sacrificing on the sponge thickness.

Which rubbers u use

 

[kapahoo]

Sponge thickness is beneficial when attacking but bouncier in short game.
Between the 2.1 and 1.9 T05, I suspect a large amount of table tennis players would fail a blind test though...

 

[Tony's Table Tennis]

Which rubbers u use

at the moment, H3 on FH, and D09C on backhand

 

[igorponger]

SAFETY FIRST

Yes, we do strongly prefer 1.9 over 2.1, largely for safety reason.
Be aware please that China hucksters NEVER manufactured rubber forgery measured under 2.1 millimeters. Our aforesayed preference of 1.9 мм comes very, very reasonable, you can see.