Speed glue advice

[merlin el mago]

Yes, not also different glue: delayed DHL delivery (incomplete address) so contra said my address too long...and complained about the different glue without any answer from Kjell of Contra but you know what are they thinking about the southern people or Europe....

 

[John_]

Depends what blade you can use. I'm a backhand chop-blocker close to the table so can't use a very fast blade, also don't like Euro/Japanese rubbers because aren't linear, so I like Chinese but with booster isn't enough.

You could try a hybrid then, k3 or jupiter 3 or something along those lines.

 

[merlin el mago]

K3 only works the 3 starting weeks, after this time it seems lose the factory boost and became dead...

 

[TheLimpUnicorn98]

Hey guys,

For amateur use what's the best Chinese speed glue, of course for Chinese rubbers like H3, Rxton5, BII, etc. & if possible give link?

TIA

The most powerful speed glue is home made, buy toluene and Elmer’s rubber cement and then mix in a 60:40 ratio (toluene:cement). This will result in a much stronger speed glue than anything you can find online, you can make Hurricane 3 as bouncy as a Tenergy 05.

 

[merlin el mago]

That's a very good advice, I will try, thanks.

 

[SwingRobo]

The most powerful speed glue is home made, buy toluene and Elmer’s rubber cement and then mix in a 60:40 ratio (toluene:cement). This will result in a much stronger speed glue than anything you can find online, you can make Hurricane 3 as bouncy as a Tenergy 05.

Perhaps liquid Nitrile rubber could be a replacement，much more cheaper than Elmer‘s rubber cement：）