YINHE SATURN S1

[J-fed]

The stickiness appears when the ball is pressed with some pressure. Can lift it for 1–2 seconds, same as H3. Find huge similarities between Saturn S1 and Battle 3. Low throw, faster than non boosted H3, step behind in spin, requires extra effort for looping. Choping and service return are worse than H3. Definitely have potential for a low price, but nothing special. I will boost with 2 layers FP and update the post.

BTW Xiom Tau 55.5 is so much better, also made in China.

Great. Much appreciated.
Maybe try that one next then.

 

[Coolsta Connor]

Saturn S1 is in my hands. Red, hard variant, €15 with all taxes. The rubber is very hard - 59 degrees shore O, measured from the sponge side and 55 degrees measured from topsheet side. Topsheet is semi-translucent with a thickness and pips density similar to H3. There is a small hint of surface tack. But even VS>401 feels more tacky with higher surface friction. Uncut weight is 73.8g with protective foil, square 165x169mm.

do u have a link for this one? How is it on backhand also?

 

[belllfador]

do u have a link for this one? How is it on backhand also?

https://a.aliexpress.com/_Ew0MXMq

GHsports Store

I played BH briefly. Was difficult to loop and chop was not consistent. Even H3 BS is better on BH. But of course, that can be improved with more playtime and use of the softer variant.

 

[TTpastor]

57 degrees hardness seems a bit hard for the backhand, at my level it even seems as if Mercury II is a bit hard from time to time