Search results

couple of tall guys teaching how to hit BH

you loop against underspin and then use the exact same loop stroke when the opponent blocks, of course it will go long pay attention to/anticipate the spin coming back when the block comes back, you can loop drive or just hit it, pick the one that works for you drill: you serve underspin...

you stated that when you use XVE you shots go off the table, so it has too much tension for you XVE has relatively low tension for ESN rubbers, maybe some of the Gewo rubbers that explicitly are marketed as low tension might be better, but not by alot G09 is not springy. You have to use good...

You need rubber that will teach you how to stroke the ball. If you want hard and spinny... H3 Neo for about $20. For more $$, BTY G09 will also make you do correct strokes You supply your own power

I rarely deal with these annoying types. Since the covid days, I always arrange with a partner before going to the club and will hit with other non annoying people who happen to be there. If I am paying $15 for table time, I am not wasting it on goofs.

your setup is way too fast for your 700 level, maybe if you are getting coaching, the blade would be ok with slower rubbers I would email Cole at colestt.com and ask him to recommend a setup for your level you will learn the strokes much faster with a setup that matches your level that you can...

easiest fix - wood putty stronger fix - wood epoxy most likely cheapest fix - wood glue + sawdust, but will take more effort any method will work, go to the hardware store and pick one, all are inexpensive

Very little waste with wood epoxy, it comes in a tube and you cut off what you need and mix it up. I use the wood epoxy for other minor wood repair jobs around the house so the tube sits in storage until I need to use it. It cost about $7. Wood glue + sawdust will work fine, but you need to...

I have fixed something like this before. Use a sharp knife to remove the loose wood. Don't sand it, the rougher the better for the next step. Use wood epoxy to fill the open space. When mixed, it's like clay. Use an old credit card to scrape and shape the epoxy. After curing, the epoxy is...

Most likely Cloudflare is getting too many bot scammers/spammers from Russian IP addresses so they are getting blocked. So, Russians are banning themselves. Igor needs to convince his countrymen to stop scamming.

Adam Bobrow playing people with non approved pips in Indonesia

If you really know exactly what you want, then contact a custom blade maker like Sergio at SDC and get a blade made to your specs.

These graphs show NOTHING about humidity affecting H3 or any other tacky rubber. The four rubbers shown measured are 2 pips out, 1 anti, and Tenergy. Maybe there was too much vodka in the air.

It would be fun to try this out, but it's a little expensive for something that I may only goof around with. Has anyone seen a clone version of this on ali or anywhere else? I have thought about asking SDC to make one for me.

Get a rubber golf tee, like the ones used at driving ranges. Put a ball on the tee at the back edge of the table. Take some swings and figure out what works best for you.

ML FH not obviously better than Da Li - Big Power, Wang Liqin

DHS D40+ orange are pretty good The best I have found are the half orange/white DHS balls made for the super league, they play very consistent

I like Spinfire, many Spinfire and other SP videos on the wrm tt channel. Spinfire is much faster than 802-40

I practice regularly doing serve and receive drills with a much higher level server, so I have been watching your serve receive videos. They have good reminders to first do the basic stuff, like get in a good position, react to the serve by moving my feet and taking the right type of...