What's the fastest rubber: Fastarc G1 VS Tenergy 05 VS Thibar MXP?

[merlin el mago]

What's the fastest rubber: Fastarc G1 VS Tenergy 05 VS Thibar MXP?

 

[Dr Evil]

MXP slightly faster than T05 much faster than G1

 

[merlin el mago]

Thank you. MX-P have spring sponge?

Enviado desde mi I3312 mediante Tapatalk

 

[Haito]

MXP is fastest among them.

 

[Haito]

Thank you. MX-P have spring sponge?

Enviado desde mi I3312 mediante Tapatalk

I think that spring sponge is term under Butterfly IP. MX-P has is bouncier in my perception (I've owned both).

 

[Tango K]

Don’t know abt T05 but MX-P is a lot more direct than G1. I’d say that’s gonna be more of a determining factor than speed.

 

[merlin el mago]

Thanks for input guys. What's the softest?

 

[Tango K]

mx-p and g1, same, medium-hard.

 

[merlin el mago]

I'm using now Fastarc G-1 but the blade is an allround Stiga classic WRB to control the LP because I play close to the table. Fastarc G-1 is a very good rubber but in my combo lacks of power, used before T05 but more expensive & less direct than Fastarc G-1, used also T64 dut didn't liked the spring sponge so that's the reason I'm looking for a faster blade for mine FH.

 

[merlin el mago]

mx-p and g1, same, medium-hard.

I used T05 and for my taste it's also medium-hard.

 

[yogi_bear]

Isn't tenergy about 38 degrees making it like 48 or 49 degrees for esn? Mxp is the fastest. I think both g1 and mxp are at 47.5 degrees.

 

[merlin el mago]

I feel T05 soft than Fastarc G-1.

 

[Haito]

I feel T05 soft than Fastarc G-1.

T05 has softer and thinner topsheet. Max thickness of Fastarc G-1 is 2.0mm because of that.

 

[Kolev]

MXP initially is the fastest but when the factory tunning is gone the magic is over

 

[thomas.pong]

MX-P is the fastest, followed by T05.

G-1 is the least fast and most linear of the 3, also the least bouncy and the most controllable.

MX-P and G-1 are 47.5 deg, T05 is a bit softer between 46-47 deg.

 

[MonsterFZD]

No doubt MXP fastest, t05 second, G1 slowest.
T05 G1 are spin-oriented rubbers, they're not good at speed, although t05's speed is not slow
For speed-oriented rubbers, MXP, bluefire m1, desto f1, coppa jo series are all very fast rubbers.

 

[merlin el mago]

I'm weighing to use T05 1.8 mm to keep the spin and increase the speed. What do you think?