Search results

A nice tip to clean rubber, if you don't have a sticky protection sheet on hand: I use a length of tape used to close cardboard box. Apply tape to the rubber then remove. Repeat all over the rubber. The tape will remove all dust. The rubber will be very clean and tack will be restored. Apply...

Also you can lob a few balls, forcing him away from the table. If you force him away he can't enter a pushing rally.

Medium soft.

It's the same ITTF number on the topsheet than the Moon Speed. I assume it's the same topsheet, only the sponge is different. I will pass on this one. I have a 729 dragon L on the way. Looking forward to test it.

Yinhe Pro 01, i use this blade as my backup and also to play again with old rubbers. I want to use some old rubbers for training on my return board. They still play fine but got retired too soon. And thinking about ordering a sheet of 729 Dragon L. Why not. Life is short.

Big Dipper in blue! :love:

The thing i didn't like about J3 asia is that Yinhe put a layer of sticky glue on the topsheet to get it tacky. You start playing with an ultra tacky rubber, but four or five weeks later some areas of the topsheet are grippy, and other are tacky. The playing caracteristics change over a short...

Someone tested the Dragon L on the backhand? Looks like an interesting rubber.

I have maybe 40ml of seamoon left in a bottle. I put it in the freezer, and after it melt at room temperature i dosen't seem to have changed in appearance.

I use deionized water. I think that minerals in tap water stain the rubber over time. Especially the black rubber. And i can use it to mix my car antifreeze if needed.

I would guess you use 2ml for each layer. 1 ml of water = 1 gram, but oil is less dense than water, maybe 0.8 to 0.94 grams. For 3 layers you are adding 5,4 grams of oil, give or take.

I ordered two Yinhe moon speed from CHINA TABLE TENNIS, and i received two Yinhe moon speed. No problems. I have 15 orders on Aliexpress and never had any prolems.

11-9 Dan. Why not. Keep dreaming and make it happen!

If your refer to the Tiefenbacher study, section III.2: "The difference between gluing conservately and speed gluing is bigger than the difference between a 1.3mm and 2.1mm sponge." They also found a 12% increase of rotation for the same racket stroke. So for the same rubber you get a very good...

A friend of mine put baby oil on the rubber side. He said it was nice. I doubt it. If you are bored you can investigate this for us. Happy boosting.

I play close to the table and punch block all my oponent opening loops with my BH, or i counter loop with my FH. I like the outer ALC for the reduced vibration and it's easier to block. I feel i have more control and better speed. My nickname is "The Wall". 😁

I used a dremel tool to carefully sand the wing on my Pro 01. Then finished with fine grit sandpaper. Arylate is very hard to sand and if you do i t manually it makes bumps.

I tried J3 39d yesterday on FH. I'm not sure yet, Speed is good but it seems to lack spin. I will play more with it and maybe when the tack wear off it will be better for me. I have Moon Speed medium on the BH and also this is an amazing rubber! It's just perfect for me. 😉

Xiom 36.5 ALX fit this description.

You change your grip between your BH and FH? For me i add a little more pressure with my thumb on the BH stroke, but i don't change my fingers position. It help with the wrist action. I don't have time to change my grip during a match. Changing your grip cause more problems. Practice your BH...