Search results

Hit softer... Cheers L-zr

Acuda S2 and Rakza 7 are very similar. I think Rakza 7 feels a little harder that’s all. It also may yield a little more spin. Cheers L-zr

Sure, all the way upto 12% depending on the yeast. But 5-6% yields the best result. I can make 'em pitch black if You want, so black You s--t coal :) Cheers L-zr

We drink pretty much the same as anywhere else. Mead that was in the old days about 1000 years ago. I used to brew my own beer. Only ale then, no lager. The one where the yeast works in room temperature ~ 20 celsius For summertime check beer is my favorite. Cheers L-zr

It should be crooked… But I must say I like German beers… Weizen not as much as Märzen as served at Octoberfest. But a Weizen doesn’t make me frown either… Cheers L-zr

It does not need to be in the middle on the mm, Putting it on crocked is a lot worse. Cheers L-zr

Yeah, but the pips screws me up… It’s hard to cut around them., But luckily I have edge tape to hide it… Cheers L-zr

I’m with saiph it’s the cutting… Cheers L-zr

No I have not. I will try the blue sponge first. I don’t spend so much time far behind so I can live with it short term. Just need to be careful with my shoulder. Cheers L-zr

Just weighed the OS and BS same hardness same thickness in the package. The BS was 4grams heavier so I figure 3grams mounted. Not too bad actually. Cheers L-zr

My BH requires some catapult and speed so Chinese style rubber is out… Donic Bluegrip or Accuda S2 works fine. H3 is for FH. You say BS is more dense that implies more weight. Hmm OK we shall see. Cheers L-zr

I will try blue sponge, I have a sheet. Another thing I haven’t tried the commercial OS even yet, will do that too. Thanks Cheers L-zr

Absolutely correct, My swing is long and timing the wrist is difficult at that speed. I tend to shorten the swing close to the table… From position 3 I miss Tenergy05, but I don’t spend too much time there and H3 is soooo much better close to the table. Can’t have everything 😁

I have to ask You. Does the blue sponge have a higher speed potential? And in this case is it easier accessible? The reason I am asking is I’m playing with H3 provincial 39 OS. I have to hit so hard from position 3 that I’m worried about my shoulder… It would be nice to get a little bit more...

Vega Europe is way softer than Rakza Z. X5-M is much closer… I am playing with Donic Bluegrip S2 which is something in between. I think they are all lighter than Rakza Z. I also like Glayzer (normal). Cheers L-zr

All blades with a top layer of spruce is made in Germany. My favorite series World champ 89 all 3 of them have a spruce top layer and are made in Germany Cheers L-zr

Wood is a live material, so there will always be differences. No two blades are identical. Cheers L-zr

No such thing as a "best" rubber... Cheers L-zr

H3 is not that sticky either. I think is an advantage because it speeds it up a tad and over time it doesn’t change as much. Cheers L-zr

I played one when I quit the sport back in 1975. It should be pretty slow by today standard. Cheers L-zr