This user has no status.
Member
Harty, I'm getting a bit off-topic. You have a good offer for H3 Neo commercial H40 and H41 (I wouldn't mind non-Neo, but that is sold out). Anyway, the available thickness is 2.1, 2.15, 2.2. Question for me is, should I take 2.15 or 2.2. Don't get me wrong, I don't care much about the thickness, and difference at all. My reasoning is this: the 2.15 exists, so that when you boost, you'll still be officially inside the allowed total thickness. The 2.2, you probably might get over the allowed total thickness. In my case, regional czech (KP1, now KP2), nobody gives a s..., but I am after the quality. Can it be, that due to this "being officially OK", the 2.15 quality is a bit higher than 2.2, or is it non-sense, and the quality doesn't have anything to do with it?
Attention! thickness measurement includes glue.
I admit, I never measured it, even though I used a booster.
Personally, I prefer a thickness of 2.1 mm.
When China wakes up ... the goods will be in stock again ...😠